I2250 - 深圳星恒讯一站式联网解决方案

ComIn I2250 provides standard RS232/RS485, Ethernet, and Wi-Fi interfaces, allowing direct connection to serial devices, Ethernet devices, and Wi-Fi devices. The standard wired WAN port supports the standard PPPoE protocol and can directly connect ADSL devices.

Product Details

Technical Parameter

Data Download

5G Industrial Router

5G Network | Dual Watchdog | Quick Installation and Use

5G High-speed Internet Experience

Supports NSA and SA 5G network standards, with high peak, high rate, and low latency, providing users with a seamless experience of the new era network

Simultaneous Access of Multiple Devices

Simultaneously connect 32 devices to the internet, including mobile phones, computers, cameras, and smart homes, all of which can be used

Intelligent Software and Hardware Watchdog

The product supports hardware and software watchdog, which can achieve automatic fault recovery and double guarantee high reliability of the equipment

ComCloud Management

Effectively carry out remote management of multiple devices, timely grasp the operating status of devices, and know any device failures in a timely manner, troubleshoot and maintain them in a timely manner

Applicable to Multiple Scenarios

Widely used in the M2M industry in the IoT industry chain, such as smart grids, in vehicle Wi-Fi, smart oil fields, supply chain automation, industrial automation, and other fields

图文展示(1)(1)

Hardware Specifications
CPU	32bit MIPS Industrial Grade Network Processor
Flash	16MB SPI Flash (Optional 32MB Max)
System Memory	128MB DDR2 RAM (Optional 256MB Max)
Wi-Fi	2.4GHz 802.11n MIMO up to 300Mbps Access quantity > 32 External detachable high-sensitivity Wi-Fi antenna
Installation	Hanging-Ear or Din-Rail Installation
LED Indicators	PWR LED Indicator x 1 SYS LED Indicator x 1 WIFI LED Indicator x 1 NET LED Indicator x 1 Cellular Signal Strength LED Indicator x 3
Interfaces	WAN: 1 x 10 / 100Mbps FE RJ45 Port, auto MDI / X, with 1.5KV magnetic isolation protection LAN: 4 x 10 / 100Mbps FE RJ45 Port, auto MDI / X, with 1.5KV magnetic isolation protection Terminal Block: 2.54mm Standard Phoenix Style terminal Block Connector, Support RS232 / RS485 Serial Connection. Include DC power Input Pin DI, DO SIM: 1 x Standard Drawer-type SIM Card Holder (2FF) Support 1.8V / 3V SIM / UIM card, Built-in 15KV ESD Protection Support Built-in SIM Card(Option) Power: Standard DC Power Input Jack, Reverse-Voltage Protection And Surge Protection Reset: 1 x Factory Reset Button WPS: 1 x WPS Button Antenna: 2 x Standard SMA-Female Antenna Connector, 50 ohm (Cellular) 2 x Standard RP-SMA-Male Antenna Connector, 50 ohm (Wi-Fi)
Phoenix Terminal	Specifications: 7 x 2.54mm VCC+ (DC Input) GND (DC Input) GPIO1 (GPIO Input 0 / 3.3V) GPIO2 (GPIO Output 0 / 3.3V) GND (RS232) RXD / B- (The default protocol is RS485) TXD / A+ (The default protocol is RS485)
Power Input	Power Type: 12VDC / 1A Power Range: 9~36VDC Power Consumption: <450mA (12V), Average 210mA@12V
Dimension	130mm x 135mm x 26mm
Weight	445g
Operating Temperature	-35°C to +75°C
Storage Temperature	-40°C to +85°C
Operating Humidity	10% - 95% (non-condensing)
Firmware	Linux SDK